Laser cut asistance

Hello Digifab team,

I am keen to get properly inducted on the big red lasers. I’m new to lasers but have watched a the Lightburn tutorial series. I also have some CNC experience.

In the interim until I’m inducted. I was wondering if someone could help me with a project - I need to burn a logo onto a piece of timber. The design work for the logo is done, and I’ve imported it into lightburn.

I will probably need to do some test pieces on scrap, then the final burn on the project piece. It needs to go on the bottom right corner of this board :slight_smile:

If someone is keen to donate some of their time and knowledge that would be greatly appreciated :slight_smile:


Heya Matt,
I’m around most Tuesday nights or we can organise a time on Discord to meet up and get this done for you!
Looks great!